frei
Follow these instructions for standard Darkside Studios RC graphics kits.
Last updated: August 2026
Click the guide above to enlarge for easier viewing.
Jump to a section:
Ensure RC panels are completely clean and dry. Use 91% isopropyl alcohol and a lint-free cloth to clean the surface. Remove old graphics and adhesive residue with mild heat and an appropriate adhesive remover.
Install in a heated room above 75°F. Unroll and inspect each graphic, then pre-trim and test-fit if needed. If anything is missing, contact me before peeling the liner. Keep hands clean and oil-free.
Spray both the body and the adhesive side of the graphic with soapy water. Float it into place, then use a felt-tipped squeegee or soft cloth with heat as needed. Start at the center and work outward. Reheat curved areas if necessary to shape the vinyl properly.
On 1/5-scale models, graphics may be applied over rivet depressions. Use heat and a soft cloth to conform the material. A small X-cut can help fit around a rivet.
Below 50°F, vinyl may crack or fail. Use alternate bodies for cold use when possible.
A warm, clean workspace above 75°F is best for normal installation.
With proper wet application, you can slide a piece into position before squeegeeing it down. Work one piece at a time and avoid stretching the material.
Allow the graphics to dry and cure fully before use, especially around edges, curves, and rivet areas.
Need help choosing an installation method or fitting a specific panel?
Email me before removing a graphic from its liner.
© 2026 Darkside Studio Arts LLC..
